Features

• RUNS FOR HOURS ON A SINGLE CHARGE

Product Description

12 Watt. 6 1/2 inch speaker. Drive, Input, Gain, Tone, Volume, Headphone Jack. dimensions: 11 x 11 x 6 inches. ... Read more

Features

• 6 1/2" speaker
• 11" high, 6" wide
• Drive, input, gain, tone, volume, headphone jack

Features

• 20W
• 8" speaker
• Dual channels: clean/drive
• 3-band EQ
• Footswitch jack

Product Description

"DRIVE" This 20 Watt Bass Amp All You Want. Features A 1x8" Custom Driver, Master Volume Control, 3-Band EQ, Presence Control, & A Headphone Jack For Silent Playing. ... Read more

Features

• 20 Watts of power
• One 8" speaker
• Input jack
• Volume control
• 3-Band EQ (treble, mid, bass)

Product Description

Features Tube Stack distortion, master control, two-band EQ and headphone jack. 20 watts. ... Read more

Product Description

Combine the ButtKicker2 with this new Audio Amplifier for the ultimate sound experience at a great price! This new amplifier, which was specially developed for the ButtKicker2, is able to drive up to two ButtKicker2 shakers. With one Buttkicker2 connected, the amplifier is rated for 1100-watts (a 4-ohm load). With two ButtKicker2 shakers connected in parallel, the amplifier outputs an amazing 2100 watts (a 2-ohm load). The amplifier now includes different two inputs depending on your usage. A High-Level balanced input for professional mixing consoles and other equipment with nominal signal levels of 1.25 volts. For typical home theater use, a Line-Level RCA input connects to consumer home theater surround processor or stereo preamp with nominal signal levels of 160 mVolts. Previously, a small amplifier was needed to boost the signal from most home theater processors, but with this new amplifier's design, that requirement has been eliminated. ... Read more

Features

• Low Cutoff Switch - cuts off frequencies below 25Hz (ideal for musicians) High Cutoff Switch with Frequency Control -allows you to select the point where the amplifier filters out frequencies (adjustable from 40 to 160Hz)
• Volume Control - Allows you to set the amount of vibration Low-Power Standby - saves energy by switching to a low-power mode if no sound is detected after 20minutes
• Multi-Country use - Operates on 95V to 132V or 195V to 253V. 50 or 60Hz for all voltages
• Thermal and output protection circuits - protects the amplifier from damage if an unsafe condition exists
• Convection cooling - you won't be distracted by a noisy fan during quiet moments in the movie

Product Description

The Flextone III has amp tone from Line 6's flagship Vetta, effects adapted from their award-winning MM4 and DL4 stomp box modelers, 16 classic Reverb types, and the exclusive A.I.R. II direct recording technology. Get serious about your tone. Flextone III's soul is its remarkable collection of Amp and Cabinet models - resulting from meticulous study of a dream collection of vintage and modern amplifiers and cabinets. Flextone III features 32 groundbreaking amp models built from the same amp technology found in the flagship Vetta amplifier. Flextone III includes a bunch of great stomp box models from the MM4 Modulation Modeler and DL4 Delay Modeler pedals. You'll get instant access to models based on the Maestro EP-1 Echoplex, Roland Space Echo, Electro-Harmonix Deluxe Memory Man, MXR Phase 90, Uni-Vibe, and Leslie 145. There's even a dedicated Compressor and Gate. And it doesn?t stop there. Line 6 even added 16 classic reverb types ranging from Plate and Chamber to vintage Spring. 32 Vetta-based amp models 12 Effects based on Line 6's award-winning stomp box modelers 16 Mix 'n' Match Speaker Cab options Award-winning Point-to-Point modeling technology 1x12 touring quality cabinet Powerful 75-watt stereo power amps 4 programmable amp channel memories Stereo XLR direct outputs MIDI compatibility allowing access to deep editing and the Tone Transfer library (coming soon) ... Read more

Features

• 32 classic amp models
• 12 premium digital effects
• 4 user-programmable channels (36 with optional Floor Board)
• MIDI capability for deep editing and access to Line 6 Tone Transfer Library
• Mix 'n' Match speaker cab options

Product Description

80 Watt. 12 inch eminence speaker. input, channel one(gain, voice, low, high, volume, presence), channel two(gain on, bass, mid, treble, volume), reverb, CD/line in, headphone jack, footswitch jack, external speaker jack, line out.

dimensions: 20 x 20 x 10.5 inches.
... Read more

Features

• 12" eminence speaker
• 20" (h) x 20" (w) x 10.5" (d)

Product Description

Perfect for practice or small gigs, the AC-20 offers the acoustic guitarist functionality and quality tone in an affordable combo amp. Features: Gain control; two 4" speakers; 20 watts (RMS); 5-Band EQ; Chorus; Foot Switch jack; Headphone jack; Notch control; Master volume. ... Read more

Product Description

Great thumping bass tone in small easy to handle package. The AB30X drives 20 watts of power through a heavy duty 10 inch speaker with room shaking results. Perfectly shape your sound with the presence, treble, hi-mid, lo-mid and bass controls. ... Read more

Product Description

Play to be heard...and reclaim the true acoustic sound of your instrument. The Fishman Loudbox Acoustic Instrument Amplifier makes it all possible. With an unprecedented design that boasts three power amps and tons of headroom, the Loudbox delivers full, balanced, transparent sound with incredible power. So you still sound like yourself, but you get heard like never before.Power: 250W RMS tri-amped with active crossover8? Woofer: 160W amp4? Cone Midrange: 60W amp2x1? Neodynium Soft Dome Tweeters: 30W amp116dB SPLSingle Channel: Shelving Bass and Treble; Resonant style Midrange and Brilliance; Phase Switch (feedback control); Notch Filter (feedback control); Mute SwitchFishman Analog ReverbEffects LoopXLR OutputBaffle Angle - Upright Position: 10 degrees. With Kickstand: 45 degrees, 57 degrees, 70 degrees ... Read more

Features

• Cumulative Rated Power: 250W
• Woofer Amp: 160W rms single tone sine wave @ 100Hz
• Midrange Amp: 60W rms single tone sine wave @ 1kHz
• Tweeter Amp: 30W rms single tone sine wave @ 5kHz
• SPL @ 1 Meter: >116dB SPL

Product Description

The Floor Board is ready for the road in this custom-tailored carry bag. The padded main compartment has room for the Floor Board and all your cables. Zipper goes all the way around, so bag opens fully for easy loading/removal of the Floor Board. The side pouch is just the right size for your POD to travel with you, or whatever else you might want to carry along. Heavy duty, rip-and water-resistant fabric has embroidered Line 6 logos. Also includes an easy carry handle and adjustable, detachable shoulder strap. Black with embroidered white logos. ... Read more

Product Description

The overall design is far more than just a scaled-down version of its big brother 60-watt, 2-channel Trademark 60 amp. The 100% analog Trademark 10 merges the simple-to-operate format of the exceptionally popular SansAmp GT2 pedal with the look and feel of the Trademark 60. It offers high-end, serious professional quality sound in a practice-amp-sized package. With the Trademark 10, you can travel from bedroom to motel room and from cafe to studio with a truckload of the most desirable, big tube amp sounds -- without so much as a luggage cart. Weighing just over 14 lbs., the Trademark 10 is a handsome, fully-equipped amplifier that delivers all the natural warmth and presence of the most recognized tube amp tones, and does so at any volume. For studio and live applications, proprietary SansAmp Tube Amplifier Emulation technology enables you to go straight into the mixer of a recorder or PA system via the XLR Direct Output. In addition to the 3 preset speaker styles you can choose with the flick of a switch, the Trademark 10 can also be miked. For recording, you have the advantage of being able to employ different microphones and miking techniques for even greater versatility. So you can capture all the nuances of multiply-miked, large, loud stage rigs without excessive volume. ... Read more

Features

• Special design 8 inch Speaker
• SansAmp XLR Direct Out for stage and studio applications allowsyou to go direct to any mixing console
• For live gigs, you can run directly into the PA system
• In larger venues, youâll be able to utilize the PA monitors to supplement your stage volume

Product Description

Double Support Amp Stand. Made with a high-quality, thick steel base, the Pinnacle Double Support Amp Stand not only is built to hold even your large amplifiers, but it elevates them to a level where you can easily adjust your settings. Amazing product for an amazing price! ... Read more

Product Description

40W of power splits evenly through 2 - 8" speakers, delivering more great tone at higher volumes than single-speaker 40W combos. Also has a 4-band EQ, gain control, dual channels, effects loop, spring reverb, chorus, and headphone jack. 2-year warranty. ... Read more

Features

• 40W
• 2 - 8" speakers
• 4-band EQ
• 2 channels
• Spring reverb

Product Description

As the follow-up to the best selling Spider series, Spider II embraces the same style but delivers much more. Spider II features 12 unique amp models made from combining the sounds of some of the greatest amps in history and places them all in one mean package. Spider II also features an impressive array of effects (7 different effect types, 3 simultaneous) including Chorus/Flanger, Phaser, Tremolo, Digital Delay, Tape Echo, and Sweep Echo. All effects can be easily tweaked using Smart FX, and delay times can be adjusted using Tap Tempo. Other features include a front panel tuner, Spring or Room Reverb, and a headphone out. All models include custom Celestion speakers. Finally an amp that gives you insane tone and power at a new lower price. ... Read more

Product Description

The BS-317 is the perfect Quiklok stand for large guitar, bass, or keyboard amps and combos. With the tilt-back desing you can get the perfect position from the floor, even on an uneven surface, with the adjustable leveling foot. The straight back brace will not interfere with open back cabinets, while the "Dino-Bite" locking system provides secure, non-slip adjustements. The entire stand folds flat down for convenience, but is made out of steel and arc-welded for durability, when you're on the go! ... Read more

Product Description

The CD100B bass combo features 10W of clean power driving a 6-1/2" speaker. It is equipped with a volume control, 3-band EQ, presence control, and headphone jack. 8-1/2"W x 5-1/2"H x 4-1/2"D. 15 lbs. ... Read more

Features

• 10W
• 6-1/2" bass driver
• 3-band EQ
• Presence control
• Headphone jack

Product Description

Ruberex wheel, double ball bearing, split-level, nickel-plated steel construction offers superior swiveling and weight dispersion. A friction grip stem is precision formed and securely shanked to prevent wobbling. Each caster comes complete with amp cabinet receptacle and four 14-1 round head phillips wood mounting screws. Installation requires drilling a 5/8 in. hole in amp cabinet. The maximum recommended weight is 80 lbs. per caster. ... Read more